Friday, 8 August 2014

Samsung G7102 Dad Boot Repair Done By EASY-JTAG TOOLS

<

CMD Pullup Level:1938 mV
CMD Active Level:2114 mV
eMMC Device Information
EMMC CID : 15010038574D423352003C545B173150
EMMC CSD : D02701320F5903FFF6DBFFEF8E40400C
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 03/2014 Rev.0x0
EMMC NAME: 8WMB3R , S/N: 1012161303
EMMC ROM1 (Main User Data) Capacity: 7456 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 kB
Extended CSD rev 1.7 (MMC Unknown)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
Backup saved: 8WMB3R_1012161303_20140701_1929.extcsd
Done.

Z3X EasyJtag Software ver. 1.5.9.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:1938 mV
CMD Active Level:2114 mV
Input file : F:\easy jtag\g7102\Samsung_SM-G7102_emmc_direct_dump\Samsung_SM-G7102_emmc_direct_dump\EMMC_ROM2_00000000_00400000 .bin
Writing 000000400000 bytes to 00000000 ...ROM2 (BOOT1 ROM)
Write Speed: 4262 kB/s
Done !!!

Sohidul Bokul

1 comments:

  1. dear sir
    i was updating my Samsung galaxy Grand 2 software mistakenly i have plug out usb cable
    after this my cell is dead i have try many time to boot it up but always failed no response from cell phone. then i decided to check it to any expert but he says this is hardware problem you must have to change its mother board so please help me what i have to do


    Fault
    No power on and no connectivity with computer and charger

    ReplyDelete

recoment

Google+ Followers

 

Copyright @ 2013 Full And Final Solution.

Designed by Templateify & Sponsored By Twigplay